brake swap problems

feifong

New Member
Apr 4, 2005
319
0
0
mesa
I had the brakes on my 83 swapped to 88 mustang for the bigger rotor this morning. Everything is weird on it after that. Replaced the spindle,caliper,brakes,brake hose,struts,bearings. The problem is that the steering is so loose that when i barely turn left or right it keeps turning by itself and will go all the way till it stops,Also seems like i have a bigger turning radius. When i hit a bump it wants to go out of control left or right what is up? The tires squeal for every turn i make. The dust shield is rubbing on the rotor i think. Another thing is that the rotor doesnt spin freely when i move it there is tension on it How do i fix this? The steering used to be tight. I dont know if i need to change the rack and pinion is this the same on all mustangS? 79-93 Thanks in advance
 
Im going to agree with Sroth (what the heck is a srothfuss anyways?) Im going to guess the problem is in your tie rods. you have to remove them when you change out the spindle... with a different spindle, the toe probably went outta whack, and the rods need screwed in or out depending on how far off the holes are on the 2 different spindles. i did alignments at the dealership i used to work at, and i hated every minute of it. if they didnt adjust the tie rods by eye, or they didnt realign the car when they were done, or tighten the tie rod lock nuts, ya might wanna take it and have it realigned. as far as the dust shields, did you use the same ones that were on the car before, or did you swap them from the donor car that you got the brakes from? there might be a slight difference between the 2, causing it to rub.

your wheels (looking from the top of the car) probably look like this / \ or the opposite \ / causing them to work against each other.
 
i agree...check the tie rods. kinda had the same issue, just the knuckle head that did the alignment somehow took off the dowl pin, the nut loosened and could have fallen off...i was so pissed