I am getting ready to freshen and change up the combo in my 86gt look-alike and would like some opinions on what parts other poeple think would be the best match. This is all stuff I already have so please pick from only what is listed. Im too poor to go buy more stuff. This is not a daily driver so street manners are not a real concern, the rowdier the better. So what would you do?
The bottom end is a fresh .030 89 5.0, stock stroke with speed pro flat top pistons. Good fasteners but otherwise stock. I believe the CR is about 10:1 with stock sized chambers. Ignition system is MSD pro-billet, 6AL, and blaster3 coil. Exhaust is BBK unequal shorties, BBK 2.5" off-road H and 2.5" MAC pro dumps. Trans is a T5 with centerforce stageII clutch.
Variables are below.
heads
-Dart Windsor Jr. (58cc chambers, 180cc runners, 1.94/1.6 valves)
-World Roush 200 (64cc chambers, 200cc runners, 2.02/1.6 valves)
cams
-FMS E303
-FMS B303
-FMS X303
intakes
-Edelbrock Performer RPM (non air gap)
-Edelbrock Victor Jr.
carbs
-carter 625 (same as performer carb)
-Holley 650 double pumper with pro form main body
-Holley 750 vac secondary
gears
-currently has 4:11 rear but I also have a 3:73 rear I can install
The bottom end is a fresh .030 89 5.0, stock stroke with speed pro flat top pistons. Good fasteners but otherwise stock. I believe the CR is about 10:1 with stock sized chambers. Ignition system is MSD pro-billet, 6AL, and blaster3 coil. Exhaust is BBK unequal shorties, BBK 2.5" off-road H and 2.5" MAC pro dumps. Trans is a T5 with centerforce stageII clutch.
Variables are below.
heads
-Dart Windsor Jr. (58cc chambers, 180cc runners, 1.94/1.6 valves)
-World Roush 200 (64cc chambers, 200cc runners, 2.02/1.6 valves)
cams
-FMS E303
-FMS B303
-FMS X303
intakes
-Edelbrock Performer RPM (non air gap)
-Edelbrock Victor Jr.
carbs
-carter 625 (same as performer carb)
-Holley 650 double pumper with pro form main body
-Holley 750 vac secondary
gears
-currently has 4:11 rear but I also have a 3:73 rear I can install