Building new motor

[KrazZ27]

Building new engine thinking of going with a 347 stroker and using a scat cast crank with a 3.40" stroke, 5.315" rod, and the 1.175 compression height but i am unsure about what kind of pistons to use i dont plan on running nitrious maybe a small power adder down the road what style piston do i need also do i need to run a h beam rod if im going to be under 500 horsepower and where is the cheapest place to buy these parts from and stand behind there products

 

[Farmers SN95]

fordstrokers.com Jim can get you all the parts you need for a good $$.
I did a 331 from him

 

[KrazZ27]

OK another question 347 vs 331 heard good bad about 347 if you dont run a short rod it might burn oil what about power is there a difference?

 

[Grn92LX]

347, rod size doesn't matter. I'd have Rick91GT on here www. rnhperformance .com build it. Keep it a stock block higher compression combo. If you're going to supercharge it, you really need an aftermarket block. Rick did my 347 4 years ago.