Burned up my driverside window motor.

dec322

Member
Feb 11, 2006
401
2
16
Bham AL
I've got the door panels off and wires are everywhere b/c I'm putting some sound deadening material in the doors. Well I was rolling the window up (or maybe down and the wires to the window motor was caught in track/gear looking thing. Well, it stopped. When I freed all the wires and tried to roll it up nothing happened. I think its burned up b/c there is no noise and it doesn't put any drain on the charging system. I pulled the motor out in order to push the window back up. Is there any way to test the motor? I think its the original motor......


Also, while on the subject, sometimes when I'm rolling the passenger side window up there is a long pause from the time I push the button to the window actually going up. I never have a problem with it going down and the problem going up doesn't happen if I don't take it to the bottom of the door. Any guesses?
 
you should be able to use some speaker wire, if that is all you have, and put one end on the +, and one end on the - of the battery. it does not matter which end goes where on the motor connection. if you swap the wires, it will go the opposite direction.
 
Remove the door mounted speaker & the upholstery panel to gain access to the motor. There are 3 screws (5/16" hex head, I think) that secure the motor in place. Remove them and the motor comes out without any problems. Once you remove all the screws from the motor, and it falls away from the gear teeth on the arm for the glass, the glass will move up and down. You may need a helper to hold the glass once the motor screws are out, since the gear on the motor holds the glass from sliding up or down

The motor is the same for left side or right side, only the gearboxes are different. If you can't find the complete assembly for the side you want, you can get either side and use the old gearbox on the new motor.
 
jrichker said:
Remove the door mounted speaker & the upholstery panel to gain access to the motor. There are 3 screws (5/16" hex head, I think) that secure the motor in place. Remove them and the motor comes out without any problems. Once you remove all the screws from the motor, and it falls away from the gear teeth on the arm for the glass, the glass will move up and down. You may need a helper to hold the glass once the motor screws are out, since the gear on the motor holds the glass from sliding up or down

The motor is the same for left side or right side, only the gearboxes are different. If you can't find the complete assembly for the side you want, you can get either side and use the old gearbox on the new motor.


Yeah, I removed the motor last night in order to push my window out. I guess I'll just go ahead and buy a new one. Just one of those things I guess.