if i get this kit..the c&l 85mm maf with intake, 70mm tb and plenum, do i need a retune or can i just select 85mm maf on my x2 and it will tune it for me?
c&l 85 mm maf
- Thread starter steveb24
- Start date
There's no need to replace your MAF unless it's pegged (or broke) and you're no way near it, get some gears insted 
yea well on rpmoutlet they have a kit with the c&l 85mm maf, tb and plenum for 500 bux. if i went and bought a jlt intake with tb and plenum it would be just as much, and i know mafs are expensive so i was wondering if it would be good to just get the kit.
jstreet0204
Active Member
You would be better off going the jlt, tb & plenum route. The C&L MAF's are just a housing that uses your existing MAF's electronics. They have not been shown to make any power with a corrected a/f ratio, BUT they have been shown to cause tuning problems. If you don't beleive me go on to any EEC tuning board and ask their opinions on tuning C&L's maf curves.
http://forums.modulardepot.com/printthread.php?threadid=25092
http://forums.modulardepot.com/printthread.php?threadid=25092
Crzyhrse
Active Member
When I had my Mach Dynotuned, it was actually rich with the C@L on there. They had to lean it out. My C@L works perfectly. Have'nt had any problems what so ever.
