My Stang was studdering when i started it in the morning and people told me to tighten everything which i tought was tight but i guess when ***** gets hot its get loose again so i re-tightened see if that fixes it.
Also, when i installed my CAI (ebay) no instructions sucked because i installed my intake without the bushings that are supposed to goto the bottom of the fendergaurd thus making my car rattle at idle. Anyone have any luck installing these bushing without lifting the car?
Also, can someone show me a picture of how there third party tube goes from the intake to the engine (its the 1/4 inch tube thingy that wasnt long enough when i installed my CAI so i had to go buy a new one) (i guess its a air flow balancer to the engine?) i wanna see if i did it right.
Also, when i installed my CAI (ebay) no instructions sucked because i installed my intake without the bushings that are supposed to goto the bottom of the fendergaurd thus making my car rattle at idle. Anyone have any luck installing these bushing without lifting the car?
Also, can someone show me a picture of how there third party tube goes from the intake to the engine (its the 1/4 inch tube thingy that wasnt long enough when i installed my CAI so i had to go buy a new one) (i guess its a air flow balancer to the engine?) i wanna see if i did it right.