Cam suggestions carbed 5.0/AOD

In the coming weeks I will or already have the following parts available:

1992 5.0L stock block+bottom end
Edelbrock 1405 (600cfm carb)
Edelbrock Performer RPM Intake
Edelbrock Performer Alum Heads (ported + polished)
shorty headers
2.5" Exhuast, Flowmaster 40 series
MSD 6AL
Mallory Unilite


1992 AOD Transmission (stock other than converter)
B+M 2400 Stall Converter
3.80 locking rear
17" Wheels (245/45/17) all around...

What kind of roller cam/roller rockers would you guys recommend?? I am going to be putting a/c on it before it is dropped back in as well. This wont be a daily driver, but I would like it to be civil enough to drive as if it were, with the occaisional 1/4mile or Auto-X thrown in. I was thinking I would like to see low 14's or high 13's with it (if it seems possible)

These should be the 1.90's, I am buying them from you Im trying to get an idea what to get to finish the engine off with. High 12's would be nice...

Cool, I went doing some research (I love working in IT!) and a lot of people are using that combo, I think I will join the minions. I can't wait for my frame to be finished so I can drive her again...