• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Can someone help me please

  • Thread starter Thread starter Shibbydude529
  • Start date Start date Jun 15, 2004
S

Shibbydude529

New Member
Nov 29, 2003
40
0
0
Jun 15, 2004
#1
  • Jun 15, 2004
  • #1
sup i have a stock 93 gt and the other day i went to start it up and nothin happened it didnt even give a single click but when you put the key to the start position the check oil light comes on. My dad was able to start the car by backing it down the driveway and dumpin the clutch. i was just wondering if anyone else has had this problem and what it was thanks alot
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jun 15, 2004
#2
  • Jun 15, 2004
  • #2
Here's a checklist:

Check battery, terminal connections, ground, starter relay switch (also known as solenoid) and starter in that order.

A voltmeter is handy if you are familiar with how to use it to find bad connections. Measure the voltage drop across a connection: more than .5 volts across a connection indicates a problem.

1.) Will the car start if it is jumped? Then clean battery terminals and check the battery. Most auto parts stores will do a free battery check if you bring them the battery.

2.) Check the battery to engine block ground, and the ground behind the engine to the firewall.

3.) Check the cables for cracks in the insulation, and corrosion around the wire where it joins the connector. Look for swelling of the cable’s diameter which would indicate corrosion inside the cable. Bending the cable can often reveal corrosive damage inside the cable when the outside looks OK.

4.) Put the car's transmission in neutral or has someone press in on the clutch. Then pull the small push on connector (red wire) off the starter relay (Looks like it is stuck on a screw) and jump it to the terminal that is connected to the battery. If it starts, the relay is good and your problem is in the rest of the circuit.

5.) Remember to check the ignition switch, neutral safety switch on auto trans and the clutch safety switch on manual trans cars. If they are good, then the relay is bad. See http://www.autozone.com/images/cds/...23d8019595f.gif for a very good diagram of the starter & neutral safety switch wiring

6.) Jump the big terminals on the starter relay next to the battery with a screwdriver - watch out for the sparks! If the engine cranks, the starter and power wiring are good. The starter relay is also known as a starter solenoid.

7.) The starter may be hung, loosen up the bolts that hold it on, and give it a good whack with a big hammer. Tighten up the bolts and try again.

8.) Pull the starter and take it to Autozone or Pep Boys and have them test it. If the starter fails the test, then replace it. If you got this far, the starter is probably bad.
 

SLiM JiM 156

Founding Member
Mar 18, 2002
1,024
0
36
Rohnert Park, CA
Jun 15, 2004
#3
  • Jun 15, 2004
  • #3
next time that happens try wiggling the wires on the terminals, that happened to me once..
 
D

dude5l

Founding Member
Dec 24, 2001
201
0
0
Grande Prairie, Alberta , Canada
Jun 15, 2004
#4
  • Jun 15, 2004
  • #4
My guess would be the clutch switch. Try pushing the clutch in as hard as possible while you have the key in the crank position. I've seen a lot of them like that, they just come out of adjustment.
 
You must log in or register to reply here.

Similar threads

A
Resolved Electrical Help Please
  • Alabama
  • Jan 22, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
296
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jan 22, 2026
AeroCoupe
S
Another no start thread.. pls help
  • Sarah84eyedfox
  • Apr 3, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
409
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Apr 4, 2025
AeroCoupe
L
Drivetrain 2000 GT High Idle - Pulling Out Hair - Help
  • lleonard1185
  • Jan 18, 2025
  • SN95 4.6L Mustang Tech
Replies
9
Views
602
SN95 4.6L Mustang Tech Jun 4, 2025
Leo090
L
0
V6 to V8 Swap info
  • 02_2v_Curtis
  • Jan 11, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
766
1996 - 2004 SN95 Mustang -General/Talk- Jan 11, 2026
02_2v_Curtis
0
T
Electrical Fox will crank but won’t prime HELPP
  • Tortoler0
  • Jul 1, 2024
  • Fox 5.0 Mustang Tech
  • 2
Replies
36
Views
3K
Fox 5.0 Mustang Tech Feb 10, 2025
bhowe2
B
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?