• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Car idles very rough and shuts off?

  • Thread starter Thread starter blackcobra
  • Start date Start date Dec 12, 2003
B

blackcobra

Founding Member
Apr 26, 2000
280
0
0
Dec 12, 2003
#1
  • Dec 12, 2003
  • #1
The check engine light would turn on every time I would punch the accelerator and turn off as I soon I let off the gas.The car still ran fine untill last night when It began to hesitate and turn off, my exhaust tone was much louder and different. Right now the car turns on and the check engine light is always on now. The car surges and when i press the gas the RPM needle takes awhile to com back down to idle. The smell of gas seems stronger, I made an appointment for tuesday to pull codes unless I figure out the problem myself and you guys. The car would also sometimes not accelerate when I pressed the gas the it would shut off? Help
 
B

blackcobra

Founding Member
Apr 26, 2000
280
0
0
Dec 12, 2003
#2
  • Dec 12, 2003
  • #2
Sorry forgot mods.
 
I

iWannaStang

Founding Member
Feb 11, 2001
229
0
0
Middleburg / O.P. Florida
Dec 12, 2003
#3
  • Dec 12, 2003
  • #3
FUEL PUMP!!!!!!!! I am going to say this is your problem. I had the SAME EXACT problem and came to find only 9psi of fuel going to my rails. Replaced it with a 255lph intank. Fixed.
Let us know what your cure is!

~Joey
 

DirtyD916

Active Member
May 25, 2003
804
1
38
Norcal 916
Dec 12, 2003
#4
  • Dec 12, 2003
  • #4
also cleaning out the throtle body and all those hoses in the intake and stuff around there would help a lot witht he idle.
 

stang1989

Founding Member
Nov 9, 2002
211
0
0
Dec 12, 2003
#5
  • Dec 12, 2003
  • #5
Is it overheating too? If you have a reliable gauge, I'd double check that. A bad fuel pump will cause the temps to climb and eventually shut off when the EEC pulls timing.
 
B

blackcobra

Founding Member
Apr 26, 2000
280
0
0
Dec 13, 2003
#6
  • Dec 13, 2003
  • #6
No the tempature was fine ita was at 190* give or take. Thanks for the replys, is there a way to test my fuel pump to see if its bad? thanks
 
B

blackcobra

Founding Member
Apr 26, 2000
280
0
0
Dec 13, 2003
#7
  • Dec 13, 2003
  • #7
A shop had an opening today so I dropped off the car. They called me and told me that my computer wasnt sending and signals to my mass air. He said the mass air has power but the computer is not reading the signals. He said to replace the computer with a used one from a junkyard. Does his info semm about right?
 
B

blackcobra

Founding Member
Apr 26, 2000
280
0
0
Dec 14, 2003
#8
  • Dec 14, 2003
  • #8
WTF, now the car is running fine I havent done anything to the car and all of the sudden its cured. The mechanic said the same problem may occur in the future if the computer is the problem.
 
C

californiaHG

New Member
Dec 9, 2003
9
0
0
Dec 14, 2003
#9
  • Dec 14, 2003
  • #9
I have a '92 LX 5.0 and I have that exact same problem... if you replace the computer and it fixes it, post up on here again, because it would be nice to not have to rev my engine up every time i want to go anywhere. I mean it turns heads, but if it stalls out, you know, its a little embarassing. By the way, your mechanic was right when he told you it would come back, its been coming and going on me for about a year now.
 
B

blackcobra

Founding Member
Apr 26, 2000
280
0
0
Dec 14, 2003
#10
  • Dec 14, 2003
  • #10
I'll be swapping the computer on Monday, l'll keep you updated.
 
J

jerry beach

Founding Member
May 20, 2002
2,671
0
46
Ocala,FL
Dec 14, 2003
#11
  • Dec 14, 2003
  • #11
I have seen this problem. Does the prob seem to be related to moisture? Humid air? Try unplugging the MAF if the car acts up. If the car runs much better, then there is a good bet the puter or the MAF is bad. And if the shop says it tested bad, it may very well test good now. All you need is a low impeadence ohm meter to test it and the Probst book. Its not that big of a deal to check one out, you just have to take your time and follow the instructions, letter by letter, thats what is hard for me sometimes.
 

fordman54935

Member
Jan 10, 2003
301
0
16
Wisconsin
Dec 14, 2003
#12
  • Dec 14, 2003
  • #12
Check your EGR valve. The symptoms you describe might be caused by this. Worth checking out. Good Luck!
 
You must log in or register to reply here.

Similar threads

I
Innova scanner not working 88 5.0
  • Idkwhatimdoing
  • Jul 9, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
71
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 13, 2026
General karthief
C
Engine Idle cuts out
  • claypoolxx
  • Mar 7, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
25
Views
753
Fox 5.0 Mustang Tech Friday at 5:04 PM
alutwon
P
Repeated P2004 DTC trouble code with no apparent symptoms
  • poehitman
  • Mar 11, 2026
  • SN95 V6 Mustang Tech
Replies
2
Views
190
SN95 V6 Mustang Tech Mar 12, 2026
poehitman
P
2
Running very very rich
  • 2esoteric
  • Oct 31, 2025
  • Fox 5.0 Mustang Tech
Replies
4
Views
350
Fox 5.0 Mustang Tech Oct 31, 2025
Noobz347
E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
2
Views
136
2005 - 2009 Specific Tech Jun 29, 2026
ejscarfo
E
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?