• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Car Sputtering And Dieing When Starting After Car Sits 6+ Hrs??

  • Thread starter Thread starter Jordan Warta
  • Start date Start date Apr 30, 2016

Jordan Warta

Member
Nov 29, 2015
48
2
8
Apr 30, 2016
#1
  • Apr 30, 2016
  • #1
I recently had my 1995 Mustang gt with 165,000 miles taken to a repair shop to get a total A/C overhaul because the compresser was locked up. Then as I was driving my car after it was fixed out of the parking lot, the car was idling up and down really badly and was not driveable (almost like a bad vacuum leak). The mechanics found out the CCRM was bad and replaced it, however this one was defective and it screwed up the fuel pump. So they replaced those, as well as battery ground wire and some other wires.

When I got home that day I replaced the o2 sensors as the car had CEL light on since March due to a bad o2 after midpipe installed.

This brings me to the PROBLEM, ever since I installed the o2 or the mechanics did whatever they did (not sure what is causing the issues but my car drove fine home from mechanics or maybe it was already warm so symptoms did not show); Anyways when my car sits overnight and I go to start it in the morning it starts fine, but then it sputters almost dieing maybe happened 8 out of 10 times in past few weeks. If I restart it instantly it starts and runs fine. A few times this happened the battery light went off. Also sometimes if I back up or go forward after starting it after it has sat overnight, it will almost act like it is going to die and it loses power/hesitates but then picks up and drives fine again. Another thing I have noticed on starts after it sits for a while is the exhaust not consistent, and this makes it more likely for it to hesitate. This hesitation, has occured alot more often since the car went to the mechanics, it maybe happened twice rarely I took it to the mechanics.

When the car is already warmed up i.e. if I drive somewhere 10 miles down the road then get back in and drive these symptoms do not show up. I drove it 200 miles home with no issues. New battery as of January, alternator tested in January and it was good.

Some other points, not sure if I am imagining it or didn't notice it before but sometimes I smell gas after turning the car off outside the car. Also one time when the car hesitated when driving the headlights flickered, another situation the battery gauge fluctuated a bit. So not sure if its electrical issue or fuel related.

Sorry for the long post. Any ideas on what this may be before I spend more money?
 
Last edited: Apr 30, 2016

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Apr 30, 2016
#2
  • Apr 30, 2016
  • #2
Do the standard thing and dump the codes.

Dump codes sticky

Look at the top of the 5.0 Tech forum where the sticky threads are posted. One of them is how to dump the computer codes. Codes may be present even if the CEL(Check Engine Light) isn’t on. I highly suggest that you read it and follow the instructions to dump the codes. http://www.stangnet.com/mustang-forums/threads/how-to-pull-codes-from-eec4.889006/

If you don't get anything but an 11, replace the ignition switch.
 
Reactions: DuderMcMerican

Jordan Warta

Member
Nov 29, 2015
48
2
8
May 14, 2016
#3
  • May 14, 2016
  • #3
jrichker said:
Do the standard thing and dump the codes.

Dump codes sticky

Look at the top of the 5.0 Tech forum where the sticky threads are posted. One of them is how to dump the computer codes. Codes may be present even if the CEL(Check Engine Light) isn’t on. I highly suggest that you read it and follow the instructions to dump the codes. http://www.stangnet.com/mustang-forums/threads/how-to-pull-codes-from-eec4.889006/

If you don't get anything but an 11, replace the ignition switch.
Click to expand...
I had no trouble codes for this issue I did buy an ignition switch but haven't got around to replacing.

I did however swap out the catted x-pipe for an offroad h-pipe, and I tested it out driving and immediatly on accelerating the CEL light went on for 10 sec then went off then did this about three more times before turning off for good. Scanned and got codes o2 sensor always lean code for CM and KOER codes (were not there before installing offroad pipe). I noticed there is a ticking when accelerating too and car feels slower than before installing offroad midpipe. Is this probably an exhaust leak so I should check all the connections for the headers to midpipe to catback?
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
May 14, 2016
#4
  • May 14, 2016
  • #4
Jordan Warta said:
I had no trouble codes for this issue I did buy an ignition switch but haven't got around to replacing.

I did however swap out the catted x-pipe for an offroad h-pipe, and I tested it out driving and immediatly on accelerating the CEL light went on for 10 sec then went off then did this about three more times before turning off for good. Scanned and got codes o2 sensor always lean code for CM and KOER codes (were not there before installing offroad pipe). I noticed there is a ticking when accelerating too and car feels slower than before installing offroad midpipe. Is this probably an exhaust leak so I should check all the connections for the headers to midpipe to catback?
Click to expand...

Yes.
An exhaust leak can set codes 41 and 91.
 
You must log in or register to reply here.

Similar threads

A
1987 5.0 speed density Foxbody crank no start
  • Alan2204
  • May 23, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
313
Fox 5.0 Mustang Tech May 30, 2026
Mcmahst
B
Engine Another no start after washing engine bay
  • bruno
  • Apr 26, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
24
Views
723
Fox 5.0 Mustang Tech May 7, 2026
AeroCoupe
E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
2
Views
138
2005 - 2009 Specific Tech Jun 29, 2026
ejscarfo
E
I
98 Mustang GT dying
  • ItsMason
  • May 14, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
3
Views
132
1996 - 2004 SN95 Mustang -General/Talk- Jun 25, 2026
lenzgt
L
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
264
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?