I got the carb list number, it is 4776-2. I will get the cam specs tomorrow after I get off work. Been busy with moving and stuff 
Carb question
- Thread starter ID89GT
- Start date
Well I started it up and shut it off. The fuel level was right at the bottom of the sight like its suppose to be so I will check it again tomorrow to see if it goes down at all.
Well I checked the fuel level today and it is still right at the sight hole so it is not leaking.
txstang84
15 Year Member
Good start. Did you already adjust your idle mixture screws and find out those can specs? I'm with Mike on this one...if you're only drawing 5" vacuum at idle, there's something not right at all about that. Advancing the timing will effect the idle vacuum but only to a point, and of course too much timing can be a bad thing.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Similar threads
