ok it started out i was just going to change the pilot and throw out bearing but I decided to change the clutch since I was down there and didn't want to deal with that starter again in six months. Well I put everthing back on and the car runs but when it goes into gear nothing happens I don't even have to press the clutch in to shift through the gears. It just sits there running as if it were in nuetral. Any suggestions and the tranny is perfectly fine. I think it is a throw out bearing issue because the fork seems really close as if it was already pushed in ? I am going to mess wth it tomorrow but I though i would ask some of you for suggestions.
Thanks in advance.
Thanks in advance.