Alright so I installed TF upper and lower intake along with a Accufab 75mm TB. I started it up last night seemed fine a little rough but ok. Check engine light is on and I am not sure why. Any idea?
Check Engine after intake install?
- Thread starter PhLoBuS
- Start date
-
Sponsors (?)
Umby
New Member
BLOWN 5.0 FOX
Member
If i was a betting man I would say ...somebody... forgot to plug a vacuum hose in
Lets hope its as easy as that.
Good Luck !
Lets hope its as easy as that.
Good Luck !
Yeah I fixed it, My CAI was not fastened and it was reading incorrectly. its fine now, time to bring it for a ride
86T-Top
Founding Member
I would still pull the code to see what it is. I can't really see your CAI not being fastened properly to cause a code. Unless you meant that your MAF was not plugged in correclty, or there was a leak in the air tube after the MAF.
Mario
Mario
Yeah there was a leak it was like halfway on, did not think it would effect anything just wanted to start up the car before everything was securely fastened. its all good now
BLOWN 5.0 FOX
Member
I can see this- change the amount of air that is metered into the mixture- gets it all fajangulated GOOD WORK
Similar threads
