• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Drivetrain Chirping noise

  • Thread starter Thread starter flashback87
  • Start date Start date May 27, 2019

flashback87

Member
May 18, 2010
345
4
19
Cleveland, OH
May 27, 2019
#1
  • May 27, 2019
  • #1
I've been doing a lot of research to determine what is causing a chirping noise when my clutch is engaged and I'm hoping you guys can give me some guidance.

I depress my clutch, put it in 1st gear and start to let off clutch pedal. When I get to the engagement point I start to hear a pretty loud chirping noise for a few seconds then it goes away. It seems that is the only time it chirps... at the engagement point in 1st gear.

After a lot of research it seems it could be the throw out bearing and lack of preload or it is just going bad but from the post i read it seems people have a slight chirping noise all the time until the clutch is depressed. Mine is only at the engagement point. At least that all I can hear but my exhaust is pretty loud. I got a new cable and I believe have plenty of preload on the clutch.

So, I'm trying to determine if my throw out bearing is going bad or if I need more preload. What do you guys think?

The throw out bearing and other clutch somponents were replaced less than 10,000 miles ago.

Thanks!
 

General karthief

wonder how much it would cost to ship you a pair
Mod Dude
Aug 25, 2016
27,827
10,508
203
polk county florida
May 27, 2019
#2
  • May 27, 2019
  • #2
It also could be the pilot bearing or even the bearing retainer that the throw out bearing rides on, the throw out bearing slides back and forth on the retainer when you push the clutch peddle.
 

flashback87

Member
May 18, 2010
345
4
19
Cleveland, OH
May 30, 2019
#3
  • May 30, 2019
  • #3
Is there anything else I can look for or try without removing tranny?

I was hoping it was just a preload issue but again it chirps mostly when clutch is engaging and I beleive I have a decent amount of preload on the throw out bearing.

Can you have too much preload?

Thanks!
 

NurseGuy

Active Member
May 27, 2019
109
17
28
Sylvania GA
Jun 25, 2019
#4
  • Jun 25, 2019
  • #4
Mine was doing this, turned out to be the retainer sleeve (quill tube) (throw out bearing tube) had broken off at the base. It was spinning with the TOB and chirping. While installing new clutch, it was discovered and now I'm having it replaced along with the pilot and TOB. Hopefully this will be the last time I have to do this. I was told that if your tube is broken, it will only cause the new TOB to go bad and eat into your clutch. So...... hopefully for you this isn't the issue. It has been a royal pain in the ass to get fixed. A new bell housing was even mentioned yesterday but I'm hoping the transmission shop guy can bang the old one out and press in a new one. Let me know what you find out man.
 
You must log in or register to reply here.

Similar threads

M
85 Capri 5.0 transmission rattle
  • Mamaclean
  • May 2, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
2
Views
107
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 17, 2026
Mamaclean
M
Electrical MSD Blaster TFI Coil 8227 loud Chirping Noise.
  • PonyGTrider
  • May 25, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
25
Views
908
Fox 5.0 Mustang Tech May 31, 2025
PonyGTrider
S
Drivetrain Downshifting from 3rd to 2nd issue
  • Scott_S
  • Apr 23, 2026
  • Fox 5.0 Mustang Tech
Replies
11
Views
394
Fox 5.0 Mustang Tech May 9, 2026
Scott_S
S
B
Engine Strange Noise
  • burntokita
  • May 8, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
330
Fox 5.0 Mustang Tech May 11, 2026
keel
B
90Gt squeal/chirp when hot
  • Bvoss59
  • Jun 12, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
23
Views
567
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 14, 2025
General karthief
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?