Cleaning the MAF

Rubbing alcohol on a Q tip or use electrinics cleaner that doesn't leave any residue.

It's been my experience that using the electronics cleaner (aerosol) is about the best way to clean it, without worrying about touching the electronics inside the MAF.

I've always done this after re-oiling my air filter, it's supposed to get the air filter oil off of the MAF..........dunno though

Grn92LX said:

Rubbing alcohol on a Q tip or use electrinics cleaner that doesn't leave any residue.

Click to expand...

Exactly. But if you use the alcohol & q-tips method (my preference) ..... be extremely careful not to break the filament.

i use electrical cleaner--no problems, just smelled funny when the engine burned it. i wouldn't wanna risk foking up the wires via the q-tip method... my ****zy luck.

TB cleaner will be fine. Just make sure it air drys after and be carful with the wire, its not as frigale as ppl say just dont be a retard and be gental with it. Do a seach for TB cleaner but I used it and its fine and I know others have as well.

Best solution to cleaning any electrical contact is Wurth USA Contact OL. It will not damage any plastic or rubber like alcohol does. Check it out at WurthUSA.com

Has anyone gotten the sensor itself out? The only way I could clean my was to remove those security torx T-20 for the plate, and put an alcohol soaked q-tip and cleaned them from the big plastic box. I don't see how you could get the sensor itself out.

no u just use torx bit take off plastic top then u see the wire.

Good to hear I wasn't supposed to actually take it out, lol.

I originally took the entire mass air meter out of the car and used a long q-tip and tried to clean the wires. However, your depth perception isn't that great when reaching for the sensor, so I went out and bought the security torx heads and took it apart. That was SO much easier. IMO, the only way to really get the sensor clean is gently using a q-tip, just spraying the wire won't necessarily get all of the build up off.

I just sprayed the wire with tb cleaner, and you could see a difference, it changed color. Was black when i took it out. It did make a difference though, and solved alot of my pinging.