What a great article...
I have many problems which associate with the cable binding. Excessively hard clutch pedal, grabbing right off the floor, etc.
I just don't know what I did wrong. I have routed the cable the same as from the factory.
I'd have to agree with the OEM products. I threw the Steeda cable in the trash seven years ago and put the OEM cable back on. When it broke, I went to a an adjustable unit again. It didn't last long.
I am wondering if I could possibly have a clutch problem that is leading to all of the systoms above minus the improper routing of the cable. Note: The cable broke around four inches from the end which connects to the quadrant. It's been so long, but I only remember one connection on the Steeda quadrant.
If I have to change the clutch, does anyone know of the easiest clutch pedal effort on the market? I depress the clutch around 100+ times day during my daily commute to work. No Fun!
Thanks for the response.
Dragnazz5.0...
I seem to have a jacked up appearance on my stang after installing the Lakewood Lift Bars. I have them setup in the middle spot, however was wanting to lower the bars to the lowest setting. How is your car setup, and do you have any problems with the driveshaft angle, etc?