Clutch Pedal Sticking

Well known and discussed problem. 2013, andmime did same thing. I did two things at the same time and one or both worked. I put in a seperate clutch fluid reservoir with high temp dot 5 fluid and tried to get as much of the old stuff out as possible. I also removed the "granny" spring that helps push the clutch pedal down. Have had no problems since. Also filled trans with Royal Purple symchromax which eliminated 1st to 2nd gear grinds on quick shifts. Really low viscosity trans fluid does not work in my mt82.

Need to make a correction here. Not Dot 5 but the Dot 4 compatible high temp - I think DOT 5.2 may be correct. Make sure it is compatible with the DOT 4 that is in it to start with.

So, actually, it is DOT 5.1. Hell getting old. The reason I went to this solution is that I have had some experience with brake fluid boiling and the brake pedal behaves exactly like the clutch in my Mustang, a 2013 GT 5.0 manual. It is hot in that bell housing and at high engine speeds, hotter still as that air in there whips around at the speed of the edge of the clutch assembly. 5.1 is amazingly expensive so gird your loins if you go that route.