clutch problems

jssblues

New Member
Jul 19, 2008
31
0
0
just put my fresh rebuilt motor back in with the same trany and clutch but now the clutch feels to tight.... i know it is at least kind of disengaging the clutch but not all the way, it just doesnt slide into gear like it used to.....
any help would be greatly appreciated
 
How do you know it's not an adjustment issue?

To me, a tight clutch is one with preload. This makes for very quick disengagement. You note that yours is tight but doesnt seem to disengage all the way. Is that correct?

How was the car shifting before the R/R?
How old is the cable?
Do you have a stock quadrant/pawl or aftermarket?
Have you tried adding preload to see what happens to your Point of engagement?


A little info about your trans, clutch and clutch linkage would have been helpful.

Good luck.
 
I am having the same problems with my clutch. We just finished putting in a new shortblock on my 06 Mustang. Did have to change the flywheel due to the bolt pattern on the new crank being an 8 bolt and the stock was a 6 bolt. The car runs great, but when you go to put the car in gear it is very hard to shift and the clutch seems like it does not want to disengage. Could this be a problem with the pilot bearing? The transmission has not been touched and the clutch is stock. There were no problems with any of this when we changed the shortblock. Please help!!!
 
Check your routing for pinches or sharp bends and make sure that your cable is not binding. Also look at the throw underneath the car to see if you are getting your full throw on your trans.

Walz