Clutch to pressure plate question

[a_k]

Pressure plate to flywheel question

I am just about ready to get everything in my car and I have a little dilemma. I have a spec 28oz flywheel that has already been balanced and a centerforce dual friction clutch. Only 3 of the holes from the pressure plate line up to the flywheel line up. I think 5 is normal but I dont remember. Am I stuck to ordering a spec clutch?

Thanks

Adam

Sorry I think these labatt's have gotten to me I ment pressure plate to flywheel question

 

[PoonRacing]

All small block are 6 bolts and 3 dowel pins.

 

[a_k]

Oh ok, so its not right that only 3 bolts line up... Anyone want to buy a centerforce dual friction with 300 miles on it haha.

 

[2muchtime]

300 miles as in you bought it used ??

 

[a_k]

No I ran it for 300 miles last year before I had a few problems with my motor, since I was being stupid and impatient. It felt fine but I know that's not right.