Cobra intake, 24# injs, 76mm MAF install planned for Tuesday any suggestions?

[deadly97snake]

I am basically gonna go with the Edelbrock install instructions from the 94/95 GT and Cobra FAQs page. Also I will be using my Haynes manual. He is my part list, am I missing anything? BTW my intake has been port matched to fit a Felpro 1250 gasket.

1. Upper and lower Cobra intake with all the bolts.
2. new Felpro 1250 gasket
3. new EGR gasket
4. Upper to lower gasket
5. Thermostat gasket (I already have the 180* thermo)
6. RTV gasket sealent
7. compressed air
8. pipe dope
9. Lacquer thinner or acetone
10. Electrically-conductive sealent (for the temp sending unit)
11. One gallon of coolant
12. Eight 24# injectors
13. C&L 76MM with 24# injector sample tube

Also I took some pics of my new intake I got off Ebay for $280.00 shipped!


upper:

The upper underside:

The lower underside

 

[deadly97snake]

Couple more pics,

cobra lower

close up of the cobra lower ports

 

[greenlantern]

Yeah thats where I got my intake from. Only advice I can think of is it might be wise to invest in a torque wrench. It will keep you from stripping out the aluminum when you bolt the upper to the lower.