Coilovers question?

[jivepepper]

I'm getting ready to install a tubular K-member, A-Arms, and front coilovers along with 4 bolt caster camber plates.

My question is do I just adjust the coilovers to a stock height since the rear is still stock? Or should I lower it in the front just a little? Would it be best to take a measurement before disassembling the k-member and try to match that?

Thanks.

 

[BennyBlown2v]

Yes, take measurements. Also, to get proper ride height, measure at the pinch weld seem on the lower rocker, not the center of the fender (this is a much more accurate place to measure true ride height). If you just wanna do drag racing, keep the front stock height if the rear is stock.

 

[jivepepper]

I was going to measure from bottom of the car right behind the front tire to the ground.