samishii New Member Apr 14, 2005 10 0 0 Michigan Jun 2, 2005 #1 Jun 2, 2005 #1 Can I get any ideas on how I might be able to raise or lower compression ratio? I know the heads will have an effect on it. But I was wonder if there are other possibilitys? Thx.
Can I get any ideas on how I might be able to raise or lower compression ratio? I know the heads will have an effect on it. But I was wonder if there are other possibilitys? Thx.
AdRock Member Nov 13, 2003 521 1 19 South Texas Jun 2, 2005 #2 Jun 2, 2005 #2 Longer rods, flat top or domed pistons. Have the block decked and/or shave the heads.
S SilverGTV8 New Member Nov 30, 2003 295 0 0 West Brookfield, MA Jun 2, 2005 #3 Jun 2, 2005 #3 Nope Compression is a direct relation between the head and the piston at TDC. The only way to change it is by deck height, piston dish, or both.
Nope Compression is a direct relation between the head and the piston at TDC. The only way to change it is by deck height, piston dish, or both.
