I was told by machine shop to perform a compression test to see if I have any bent valves. I had a pushrod that bent on me and I have since fixed all that but still have noise from valvetrain. So I contacted the machine shop and they said the easiest way to tell if you have any valves that are bent without pulling the heads is to do a compression test. So is there anything special I need to do for this compression test. Or do I do it the same way as if I was doing it to determine whether or not a car has blown rings. I know the machinists mentioned something about if I had any bent valves that I will not have hardly any compression on that particular one or something to that effect. Any help would be appreciated on this.