Computer Removal???????????//

Paul Perreca

New Member
Mar 30, 2005
1,085
0
0
How the **** do i get the computer out?????? LOL there is a big ass black box (not sure hwat it is) that is int he way under the dash.. i can see the bottom half of the computer... is there an easier way to get it out? HELP lol im taking it out now to put in the A9L but it looks too difficult lol


Paul Perreca
 
yo do i have to take my mother faucking dash out to get it ou?? cuz if thats the case - i aint doing it... i'll pay someone else to do it... this ****in sucks, it was supposed to be a calm saturday where i did this... god damnit
Paul Perreca
 
Remove the passenger side kick panel. Then loosen the 10 MM bolt from the center of the big connector. When the bolt spins free, pull down on the connector assembly. Remove the 10/32 screw from the lower Rh side of the computer mount strap and pull the computer out.
 
Got the computer out and ordered the new one... Pickin it up in half hour for 95 bucks. I am sooo confused w/ this conversion part though.... I am buying that conversion harness from jegs, and it says there is no splicing needed, it just plugs in, how the hell does this work????? lol paul perreca
 
What conversion harness are you using? Do you have a picture?

All the ones I have seen require you to crimp the pins on the wires and insert them in the proper place in the computer connector.
 
i don thave a pic, but its in the jegs magazine, hang on i ll write exactly what it says verbatim...

MAF CONVERSION WIRING HARNESS

"Convert your speed density system to mass air with this wiring harness. Just connect this harness to your new MAF sensor (not included) and simply plug into your existing speed density wiring harness that connects to the mass air ECM (not included). No Cutting Wires."
$79.99

Paul Perreca