Curious: How do you install piston rings?

5spd GT

"the 5.0 owns all"
Founding Member
Aug 7, 2002
9,516
6
99
Arkansas
Well I tore down my engine to the block yesterday. I still had factory crosshatch marks on all cylinders but my spark plugs were covered with a bit of oil so it is good to re-ring anyways.

Well the rings are pretty low tension and it seems like you could install rings by just squeezing them with my hand. I know you can use the rubber installers but rings seem easy to install into the cylinders...I didn't realize it "appears" that easy. Is the only risk of actually putting them in the walls is breaking them?

Also how do you set up rings? I know you don't want the two ring gaps to be inline with each other...so how would you set up rings on a 306?

What exactly does the oil ring do? What is the exact purpose of the first and second rings?

Thanks...

I am having Keith Craft install them...I was just curious what exactly they do and how to install them?
 
Also, do I need to buy piston rings with my pistons or does my engine builder need to order the rings himself for my pistons?

Can I get rings that go with the pistons before the machinist sees them since they are for the pistons...?
 
5spd GT said:
Also, do I need to buy piston rings with my pistons or does my engine builder need to order the rings himself for my pistons?

Can I get rings that go with the pistons before the machinist sees them since they are for the pistons...?
if u ordered a rebuild kit it should come with everything


EDIT: how much over is 306. i forgot. brain fart:bang:
 
Well you need to match the rings to the piston for size, ring gaps are determined by applcation, I file fit all rings. You need a rin compressor to install the pistons into the block, I also use ring pliers to install the top 2 rings on the piston with out damage. The rings will come with a diagram of how the gaps are oriented.

The top ring is the compression ring, the second ring helps keep the top ring stable.