Cylinder Head Swap

Hey All,

Can anyone refer me to a cylinder head walk through posted on the web. I have taken a long weekend from work specifically to do this, and I need a little guidance.

BTW: A little backround: Its obvious to me that I have a head gasket leak. I have aquired some gt40 heads off of a 94 cobra with the 1.7 roller rockers, mounts, and rods ( or whatever they are called.) The heads have been planned and are ready for bolt on. I know I will need some new valve covers, gaskets, and appropriate bolts, but is there anything else I am missing. Please, ANY help at all would be greatly apprecited.


-greg

Iv'e done an intake swap already and am familiar with the procedure. I actually printed the out intake install guide walk through out and used it as a guide when doing it (check out my cardomain page to see the before and after.) I have not however been able to find a good head swap walk through.
I have both the hayes & chilton manual. I even have the red mechanics manual for our cars, but was wondering if anyone posted anything even better on the web (The more pictures, the better.)

-g

Thanks for the part numbers Jake. Much appreciated.

I can tell a lot of folks have looked at my post. Cmon guys, HELP ME OUT PLEASE!!!


-g