ok so i got my shortblock back, finally, from the machine shop yesterday but i was too tired to touch it. i was planning on setting the lash today on the lifters/rockers and ran into a problem. first i got the dogbones on the passenger side of the engine and then when i went to put them on the drivers side, they dont fit. there is not enough vertical clearance to slide them on. so as i bowed my head in frustration i looked at the passenger side and noticed the dog bones weren't all sitting flat. the lifter came up too far out of the bore and the ring on the lifter pushes the dogbone up. that is the point where i went and got the noose and just quit.
i have heard of some "link-bar" lifters, but would those solve my problem(s)? are link-bar lifters the same as retrofit lifters? i'd prefer not having to fully break the bank with some $500 lifters. i just need something that will eliminate the dog bone and keep the lifters from rotating in the bore.
these say they're retrofit?
http://www.adperformance.com/index.php?main_page=index&cPath=191_192_195
these say link-bar
http://store.summitracing.com/partdetail.asp?part=CRN%2D36532%2D16&N=4294908331+4294840126+4294889096+4294908282+115&autoview=sku
i have heard of some "link-bar" lifters, but would those solve my problem(s)? are link-bar lifters the same as retrofit lifters? i'd prefer not having to fully break the bank with some $500 lifters. i just need something that will eliminate the dog bone and keep the lifters from rotating in the bore.
these say they're retrofit?
http://www.adperformance.com/index.php?main_page=index&cPath=191_192_195
these say link-bar
http://store.summitracing.com/partdetail.asp?part=CRN%2D36532%2D16&N=4294908331+4294840126+4294889096+4294908282+115&autoview=sku