fabricated 9" with an aluminum center section vs 8.8? really dont think its lighter? not sure if there is a dig difference between a stock 8.8 housing vs a stamped 9" though
as for changing gears. depends on the combo and if they are running different area's and events. down south 1/8mile has always been bigger but its growing up here. so yee you would gear different for them both.
turbo cars ive seen have 3-4 center sections in with them.
we run dont run 1/4" mile anymore or id have more data for where we trap MPH and RPM wise running out the back vs 1/8 mile
Not sure I believe that...?
Well if you're going to run 7s... Jesus. But that goes to show that an 8.8 will handle what 99.999% of dudes can throw at it with just a little modification.
Now I know another strong point of the 9" is the ease of gear changes, but how often do most guys change gears?
yea factory iron vers factory 9inch... its hard to say... the 9" back then was stamped like sharads just no bracing
if your decent with a 8.8 it takes an hour to swap gears. 35 splines and a good diff go ALONG way! Even though i talked to a dude last night with a 9" and 40 spline gun drilled axles, but he is going high 7's in the 1/4. And he drives it around the southside lol. There were 2-3 cars out last night with f1-R's an f1-A cobra too, they sound like a harrier jet coming down the street lol.
LYONS;9681485 said:Ok guys here it is, Ive had alot of request fo pics and pricing of our upper & lower torque box kits for 79-04 mustangs. We have designed this kit with a wide range of usages. It can be used from anything to your street strip mustang (doesn't require cutting out all the floor pans) to your so called pro-mod stock suspension builds. All the adjustable brackets are built with 3/16 plate & have 3/16 doublers welded on. We have went to all 5/8 holes for the mounting points (cause we all know what 1/2 will do)
- Upper & Lower kit comes fully assembled & welded. Lower comes with a tube of chromoly to weld to your rocker.
- And yes it does have stock mounting points (holes)
- We have a few kits pre-assembled that we are installing in cars now. We are about 5 days out on shipping once the order is placed. Thanks for all te interest guys! PM for pricing or call.
more "stock supension" **** for you guys!
I'll have this one in stainless, so I can prepare my lunch on it and clean it off before surgery.ok maybe i want this one!
ok maybe i want this one!
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?