Does the motor have to come out for oil pump replacement?

90_Red_LX

Member

Sep 29, 2003

668

5

19

Asheboro, NC

May 28, 2007

#1

• May 28, 2007

• #1

Hey guys, does the motor have to come out when replacing the oil pump and shaft? I snapped myn in half, and was just curious if I could raise the motor high enough or if shes got to come clean out. Anything need to be disconnected to do so? Thanks for the help, eager to get her running again lol.

 

Nibbie

New Member

Mar 10, 2007

127

0

0

May 28, 2007

#2

• May 28, 2007

• #2

I would think you would have to pull the engine (easy way i can think of), it would be hard to remove the front suspension including k-member to remove the oil pan.

 

daddystang

New Member

Aug 13, 2006

185

0

0

May 28, 2007

#3

• May 28, 2007

• #3

I've heard that you can get it up high enough without pulling it, but if you are going to disconnect everything to lift it, I'd just pull it out completely. Just my two cents. Good luck.

 

90_Red_LX

Member

Sep 29, 2003

668

5

19

Asheboro, NC

May 28, 2007

#4

• May 28, 2007

• #4

Hmmm, guess I should plan on pulling her then. I figured she might be able to be jacked up enough to slide the pan out.

 

rd

Founding Member

Jan 12, 2000

3,316

63

109

Ocean Springs MS

May 28, 2007

#5

• May 28, 2007

• #5

It can be done with the motor in, but you do have to unbolt it and jack the engine high enough to get the pan off.

I have done it both ways, and I recommend that you just pull the engine.

The effort to get the pan rails clean and the gaskets back together properly with engine in the car is not worth it.

 

90_Red_LX

Member

Sep 29, 2003

668

5

19

Asheboro, NC

May 28, 2007

#6

• May 28, 2007

• #6

Thanks a lot. I didn't even think about the cleaning phase. I'll probably sit her on the stand and check a couple bearings to be sure she didn't starve for oil before I cut her off.