doing clutch install...have question.

jmd2914

Founding Member
Sep 6, 2002
937
0
0
Napa, California
alright, i have all my sensors disconnected, tranny fluid drained, drive shaft out, x pipe and crossmember out, my question is, do i have to disconnect my clutch cable before i drop the tranny? ( i know its a dumb question but this is my first install)
 
yeah thats the easiest way to do it........4 bolts, wiggle it out......a floor jack might help..depends on how strong you are.the tranny weighs about 75 pounds.....
as for the clutch cable like i said i'm not sure, the only reason you'd have to remove it is if it has some pre load on the throw out bearing that slides over the bearing retainer which may make it a little stiffer to pull out........ but yeah if everythings disconnected remove the 4 bolts and it should come out...
 
I would remove the clutch cable now. Before the tranny is out, but it really doesn't matter, take it off now and the clutch fork won't snap back when it comes off the bearing retainer.

My tip for when your installing the tranny is to use two zip-ties tied together to hold the clutch fork to the bell housing cable guide. Makes it a ton easier to line it up with the input shaft...hope that makes sense.
 
For more info, see 5 spd gt's write-up and Jrichker's write up. They sometimes post them both on the same thread.

Good luck.