Dynotech headers

[saleen970]

I just installed a set of long tube Dynotech headers, h/f cats & x-pipe on my 06 & have to give them a big thumbs up! Great fit & good directions. Install was about 5-6hrs on jackstands.

 

[bigcat]

pics? write up?

 

[PDXStangDude]

My denaro is been saved up for this purchase right now. Good to hear this feedback!!!
bigcat, I can do the things you asked but I'm a novice wrench-head and I'm not sure how good of a right up it would be technically.

 

[bigcat]

My denaro is been saved up for this purchase right now. Good to hear this feedback!!!
bigcat, I can do the things you asked but I'm a novice wrench-head and I'm not sure how good of a right up it would be technically.

if you want to do a write up, just take pics as you go. when you are finished, just write the steps and tips needed for installation. not too hard. ANY information about installing a part is helpful to others. if you want examples to follow, click on the write up thread, (its a sticky) or follow the links in my signature.

i may also be able to get it published on the stangnet homepage, if you wish.

write ups dont have to be written by ASE techs, they can be from anyone.

 

[saleen970]

The only thing that I would say i would do different than what the Dynotech directions say is...they said to disconnect from steering shaft & move the rack forward. Just for the heck of it I tried installing the header without doing this step & the header went right into place. So I would skip that step & do everything else they say. Great directions with pictures otherwise. I have a Procharger on the way so Ill have to take pics & do a write up on that.

 

[bigcat]

sounds like the instructions actually help!

I have a Procharger on the way so Ill have to take pics & do a write up on that.

sweet