eagle crank queston 410w

[nevin15]

Hey everyone I know youve probably been asked this before but Im building a 410w with eagle 4340 rotating assy. and my crank snout measures .001 smaller than my stock crank. I already ordered a romac steel/alum. balancer and I was wondering if it will be ok or if ill have to send it back and order the .001 smaller balncer? Anyone did this or ran into this? All i needed was this to have it balnced and ready for assy. I have a feeling Im getting delayed....

 

[nevin15]

Hey everyone I know youve probably been asked this before but Im building a 410w with eagle 4340 rotating assy. and my crank snout measures .001 smaller than my stock crank. I already ordered a romac steel/alum. balancer and I was wondering if it will be ok or if ill have to send it back and order the .001 smaller balncer? Anyone did this or ran into this? All i needed was this to have it balnced and ready for assy. I have a feeling Im getting delayed....

hello anyone????????????????????????????

 

[mstngjoe]

You shouldn't have any problem.....wait for the Romac to show up and test it.

 

[SoCalCruising]

My balancer came in under sized and had to be honed to fit the snout on the crank of my motor. So, yeah, wait until you get your balancer in. It may be fine.

 

[C0V3R]

I dont think youll have a problem. A romac may be that precise but lots of other balancers wont be.