So i had a fire in my engine bay that burnt most of my computer harness, i got a new harness, however i think it may be a manual (my car is automatic) due to the fact that there is a round connector at the computer not being used. I have power to injectors, so my computer has power. When i turn on the ignition my dash lights up, and i get power to the coil, so my ignition switch is fine. The thing i cant figure out is how im getting no power to the red/blu wir on the starter relay(no crank), and absolutely no power to the fuel pump, and i mean not before or after the breaker switch at the driver side back tail light. Ive come to the conclusion that maybe the harness being from a manual has messed up my nutural/park safety swich....am i right in assuming this, and if so how can i fix it, short of pulling the whole harness out again? all input is appreciated, Ive been banging my head against a wall lol.