Electrical Problems.......

mustangfiveo198

Founding Member
May 20, 2002
145
3
19
Driving my STANG
Here is my story. About a year ago I put on some underdrive pulleys. Ever since then, little things have been going wrong with my stangs electric. One day my radio doesn't work, next month my power mirrors don't work. Then my power locks, then the power windows and gas cap opener don't work. Last big problem was my driver side door not opening any more............what happened? any ideas? I really don't want to bring it in to a auto electric mechanic just yet. I checked the fuse and they are ALL good. Any and all ideas would be great.
thanks alot.
 
The driver door doesnt open - that aint an electrical issue. Now if it wont unlock, that could be a frozen actuator.

Give more info about the rest of the issues. Do they last one day and go away, or do they hang around? How is your voltage reading when the car is idling? How old is the battery?

Electrical stuff is hard to figure out over the internet, so any and all info you can provide will help.

Good luck.
 
hissin,
thanks for the reply.
I am at a lose for what is going on.
When the mirrors, radio etc stopped working they never came back. All the readings on the gauges seem good. The battery is fine too. I am thinking about going back to the stock pulleys and see what happens. Or maybe try some different underdrive pulleys.
Any more info would be great!
thanks alot.
 
I have a sinking feeling that your ignition switch might be on the fritz. You can test it with a meter and replace it if needed (they're cheap and were a recall item on some years).

Good luck.
 
I agree with the ignition switch problem being a likley solution. That or maybe something with the fuse box. Check for voltage at the fuses for the circuits that don't work if there is no voltage to either side of the fuse it is likely your switch. Decent voltage at idle [they are all a little low at idle] tels me that the alternator and battery are ok. Other thing to look for are the ground circuits. Ckeck each one from the componet that is inop with an ohm meter to ground. Your pullies are not the cause just a considence.
Good luck
 
mustangfiveo198 said:
hissin, gary,
Thanks for the replies.
How do i check the ignition switch?
Would that be the problem for all the stuuf going on the fritzz?
I will get to the bottom of this sooner or later.
Thanks again.
Simply access the switch and look at the connector and terminals. A lot of them look singed or charred up. I also move the wires around a little (kind of goosing them) and see if a given accessory cuts out (or tests differently with your meter).

Here's a diagram of the ignition switch that might be useful.

Good luck.