Engine Engine builders: Pushrod length question...

I am building a 5.0, non-adjustable rockers.

I am using a Comp Cams length checker tool.

I come up with a perfect length being 6.215".

The only available lengths are 6.2" or 6.25"

My question is do I go with the .015" too short pushrod, or the .035" too long rod?
Will the hyd roller lifters absorb that .035", or will it make the valves too tight?
Does anyone make shims to raise up the Cobra pedestal rockers .035"?

Thanks in advance!
Dave

So, the company that made the Cobra rollers for Ford should sell a shim kit?
I'll check into that. It sounds like that is the best way.

Found it!

http://www.summitracing.com/parts/fms-m-6529-a302

I can use the 6.250" pushrods and shim them up .030" with this kit.