engine codes help

98stangv8

Active Member
Oct 3, 2003
1,036
0
36
fayetteville, nc
check engine light on...codes that came up are P0351, P0352, and P0354. The person at Autozone said they were Ignition coil A, B D circuit problems....any help on what that means. I saw on the sticky, but that didn't help much....are these the passenger or driver coils? When I drive, there is a noticable delay (occuring more the more I drive now) when I hit the gas, and sometimes it won't acknowledge the pedal being pressed...
any help would be great!
 
98stangv8 said:
check engine light on...codes that came up are P0351, P0352, and P0354. The person at Autozone said they were Ignition coil A, B D circuit problems....any help on what that means. I saw on the sticky, but that didn't help much....are these the passenger or driver coils? When I drive, there is a noticable delay (occuring more the more I drive now) when I hit the gas, and sometimes it won't acknowledge the pedal being pressed...
any help would be great!

I would just change coil packs, wires and spark plugs. If you cant afford them all just get some coil packs see if it fixes problem.
 
Measure resistance of all coils with between the coil driver pins on the coil pack itself and IGN Start/Run circuit at Coil harness connector.
Is resistance less than 5 ohms?

if you take the connector off the coil pack the two outer pins are the coil driver pins with the center being the IGN start/run. you want too connect one test lead too the CD pin ( pick one of them,then do the other) and place the other test lead too the center wire in the harness connector you removed from the coil pack.. do this for both outer wires.. for both coils.

that tests the primary side of the coil

Remove both plug wires from secondary of Coils
Measure resistance of Coil secondary between coil pack towers.
Is resistance between 12K and 14.5K ohms?


all you do to do this test is remove the wires.. and with the connector of the coil facing you.. connect one test lead to the top wire tower. and the other too the bottom wire tower.. then do this on the other side of that pack.. and the same for the other coil pack..

if the coil packs fail any of these tests replace them.. if not. . check back in you could have PCM driver problems or wirring problems.