Engine revs itself in neutral? Help please.

[gian2oo1]

Hello. I have a completely stock 2001 v6 5speed mustang (except I put a k&n air filter in and new plugs (i dont know if I torqued them correctly though)). Sometimes when I push in the clutch the engine revs itself to 3000 or 3500 rpms. then if I brake and completely stop then the engine will go down normal. Do you know what might cause this? The car has 56,500 miles on it. If you need any more information please ask. Thanks a bunch,

~Gian

 

[timeless2]

K&N got oil on your MAF, perhaps. Check the MAF sensor and make sure it's not covered in oil. Let us know.

 

[gian2oo1]

Hi,

I checked the MAF sensor. It is completely dry and there is no oil anywhere.

 

[timeless2]

Have you tried resetting the PCM? Disconnect the battery for about 15 minutes or so, then reconnect it.

 

[tomustang]

look at the IAC

 

[timeless2]

look at the IAC

IAC's suck on sixer's, too?

 

[gian2oo1]

Hello!

Have you tried resetting the PCM? Disconnect the battery for about 15 minutes or so, then reconnect it.

I reset the PCM but it didn't help. The engine still revs itself high when I push the clutch in.

look at the IAC

The IAC looked a little dirty (the peices that I thought were steel were a darkish brown colour. I cleaned it with carb cleaner and ran the car around the blocked a few times. It didnt rev when I pushed the clutch in, but I only had it out for a few minutes. I'll know for sure if it was the IAC during my commute to work monday.

___________________________________________________

Also, I found a wire that was not connected to anything. Should this be connected to the battery? It was just hanging over the windshield fluid cap when I popped the hood. It is a red wire with what looks like a green fuse on it. Here is a picture of it:

And here is a picture of the fuse that is lead off of the wire:

Thanks for helping I appreciate the responses!

~Gian