Exaust / Midpipe Question...

[highvolts]

How can I raise the connection of my midpipe and catback? It hangs lower than anything on my car and it drags sometimes (It did before my H&R SS Install also.)

Suggestions?

 

[damacman]

Loosen the bolts on the slip connectors, raise the junction of the H-pipe and after cat with a floor jack, and re-tighten while it is raised.

 

[highvolts]

Loosen the bolts on the slip connectors, raise the junction of the H-pipe and after cat with a floor jack, and re-tighten while it is raised.

Help me out a lili bit DaMacMan.. Where are these "slip connectors"?

 

[damacman]

Sorry for the confusion. Ford uses those ball & socket joints -- this is what I was referring to. Basically, the connection between the H & after-cat. I'm not too familiar with the Borla kit you've got, but this will probably be your only way to do this.