Explorer Motor Swap Questions

mikestang63 said:

B cam? oh my... the B Cam cures cancer, male baldness, dandruff , and 3 out of 4 dentists prefer it. What springs are they? You need to get them tested for pressure.

It depends on what your goal is. The reason to use an Exploder motor is for the heads and inake- essentially a GT40 package- however, you need to swap the springs as stated or IMO why bother. If you have another $175 for the cam and springs then buy the exploder motor, throw in your stock cam or a TFS 1 cam and the TFS springs. The stock exploder motor makes less HP than the stock mustang motor due to the weak springs, cam, and exhaust. If you are truly on a budget, find another mustang motor and be d0ne with it.

Click to expand...

Either way I go Mustang or Explorer it sounds like the springs should be replaced, I have heard good and bad about the b303 cam so I'm wondering if it would be much better than the stock cam from the HO motor, the springs are Ford Racing springs, the guy selling them and the cam has a large amount of Ford Racing parts he is selling on craigslist, i don't know a part number for them.

Chuckman said:

The letter cams may be old school, but for a non max effort motor where you just want a fun toy, it'd be fine.

If you're pulling junkyard motors, the explorer is probably the best start value wise unless you can find a 93-95 cobra motor for the same price. That way all you need is a cam swap and you have a better than cobra motor, and they're a dime a dozen.

Click to expand...

The Explorer motor deal fell thru due to a cracked block but I found a complete 87 5.0 HO motor from a Mustang at a good price, now I need to find a set of gt40 heads before I worry about a cam change.

I finally found a GOOD motor, it's from a 96 Explorer. So I plan on swapping in my HO cam, new valve springs/seals/kit, and an oil pump. The next question is what is the best gasket set to go with, I want to replace all the gaskets while it is apart and I don't want to have any leaks once it is in the car, anyone have good or bad luck with any certain brand of gaskets?

Those are what I used when I put the motor that is in the car now, the 1 piece pan gasket seemed much easier to install than the old style 4 piece, the the rubber intake set was nice also with the pins that fit in the block to keep them in place, the gaskets I am not sure of is which head gaskets are the best, which are the closest to the same as the OE gaskets so there won't be much difference for the push-rods. The only gaskets I didn't replace when I put the motor in 2 years ago were head gaskets and the rear main, but the motor I am about to put in will get all new gaskets. I have never pulled a rear main seal, is it OK to just use a small thin flat screwdriver to pull it or does it take a special tool? Also when installing the new seal I have heard to install dry and to lube first with a thin oil or white grease, any special tools required for installing or or is it just tap in evenly with a soft block of wood like other seals? Since I'm in my 50's I would prefer not to have to pull the trans again if I can get things done right the first time. I have done everything to my cars myself but this will be the first cam change and RMS change, I know I can do them just looking for pointers so I don't make any stupid mistakes.