I installed some new headlights recently and broke the upper pivot stud (the one that has the clip on the backside of the headlight panel). So I ordered a new passenger side housing from CJ and installed it today. I ended up having to remove it after I had it installed in order to file down the tabs on the upper adjuster so I could install the clip and ended up coming up with a nice way to remove the two lower adjusters without pulling on the housing itself. Pictures below.
The one on top is the one of which I speak:
Use a pair of needle nose vise grips (the real ones) to squeeze the tabs on the lower adjusters:
Then use something (I used the rubber grip on a hammer) to push them out using the core support as leverage:
I just wish it didn't always take me the third or fourth time installing something to figure out how to do it without breaking something.
The one on top is the one of which I speak:
Use a pair of needle nose vise grips (the real ones) to squeeze the tabs on the lower adjusters:
Then use something (I used the rubber grip on a hammer) to push them out using the core support as leverage:
I just wish it didn't always take me the third or fourth time installing something to figure out how to do it without breaking something.