Finally found my Granada swap discs, but...

Im not sure exaclty myself but the only place ive seen any kind of explanation was mustangsteve

This may be of some help

(according to his info on his page)



The page I found this info at

I was just about to post this question.

I have an adjustable proportioning valve with one line in and out and a distribution block that looks nothing like this. Since I have a GT, I should have what I need, but I can't figure out where to run the lines.

Here is what I have. Can you help me untangle this mess?

There is a line that runs from the back of the fruit jar master cylinder to the proportioning valve. There is a line from the proportioning valve to the rear brakes, I think. There is a line from the bottom of MS bowl to distribution block. The only two outlets from the distribution block must go to the front brakes.

I must have the pieces, but, for the life of me, I can't put them in some sort of order.

Thanks in advance!

--Paul

It is frustrating because, I'm sure, it is an easy thing to figure out but I can't see the forest for the trees.