Floor Crack

90limited

Founding Member
Apr 13, 2002
276
3
18
Port Charlotte FL
While restoring the interior, I found a small crack (2")in the floor pan... :notnice:

Don't know if happened before or after the subframe connectors. At this point, I am going to drill each end and hit it with the MIG. Anyone have any better ideas?
 

Attachments

  • floor crack.webp
    floor crack.webp
    24.8 KB · Views: 157
  • floor pans.webp
    floor pans.webp
    38.6 KB · Views: 150
Forgot one question... I flat destroyed the plastic retainers for the seatbelt retractor covers that mount to the sill area near the floor. Anyone know where I can get 4 new ones? The ones for the kick panel are 1" and the seatbelt retractor cover ones have a much thinner head and about ¾” dia…
 
Hmmm...

Once I got the area cleaning up and really studied it from the top and bottom, it is worse than I thought...:mad: I don't think I can get the MIG tip into the small space between the floor pan and the riveted brace that runs under the door. Anyone have any bright ideas for me?
 

Attachments

  • floor under crack 2.webp
    floor under crack 2.webp
    24.7 KB · Views: 130
Put the subframe connectors in and forget the cracks. My 79 and 82 have had cracks there for over 10 years of driving and track use. The 82 has not gotten worse at all since I installed the subframes. Have not looked in the 79 for years. I think if you don't install subframes, they may get longer, never tried it.
 
I'd do exactly what you said, drill the ends and weld them closed as best you can. If for nothing else, do it for peace of mind. You could also cut out the whole section and attempt to repair it just like you would a rust hole.

If you have the time, patience, materials and skills, you could fab up some through-the-floor subframe connectors. I've never done it myself, but my buddy did his own and its supposed to be easy if you're good with a welder. His was in a bare-interior race car though, so I don't know how that would look under carpet, haha.