Sure you can use sheet metal.I need to replace the rear passenger side floor pan and I was wondering if I could you a piece of sheet metal instead of buying a new floor pan.
They're great, with my limited experience, they fit really well too. Yes, same gauge.I was also planning on buying pans, and making patches out of them. Are the replacement pans any good? Same gauge steel, etc? Does Dynacorn make pans other than the one piece?
That's odd, the ones I got from LMR were fine and fit like a glove. Don't know what to tell you there.Yes, as far as I know, Dynacorn only makes the complete one piece pan including the trans tunnel. I've just read from other Mustang websites that the L/R sides from LMR and CJPony aren't the same gauge, and aren't any good.
OP, sorry if I derailed this thread.
And they are a vendor here with a 6% discount.Good to know. Especially from someone who is a body guy, and has used them without issue.
I need to replace the rear passenger side floor pan and I was wondering if I could you a piece of sheet metal instead of buying a new floor pan.
Have a picture of the area that needs replacing?I need to replace the rear passenger side floor pan and I was wondering if I could you a piece of sheet metal instead of buying a new floor pan.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?