I'm in the planning stages of replacing/patching my floor pans. If I'm replacing a good portion of the driver side front pan, do I need to move/remove the fuel line? How close is too close when it comes to welding near a fuel line? I know its right there next to the frame rail.
Any tips or advice for someone that has never welded before? I'm picking up a Lincoln welder from Home Depot in the next couple of days. I know MIG is the prefered way to go but I can't justify that upgrade right now so I'm going the flux core route.
Any tips or advice for someone that has never welded before? I'm picking up a Lincoln welder from Home Depot in the next couple of days. I know MIG is the prefered way to go but I can't justify that upgrade right now so I'm going the flux core route.