Flywheel question

dbarr

New Member
Jan 29, 2007
13
0
0
I recently bought a King Cobra clutch and decided to get an F1 racing aluminum flywheel also. I'm very confused about flywheel balance. The flywheel comes with a 28oz weight and a 50oz weight. I've heard ppl say that they installed aftermarket flywheels with no balance, and had no problems. I've heard other ppl say that they took the flywheel and the clutch to the machine shop and had them neutral balance it. Someone please tell me exactly what I should do. Should I have the flywheel balanced, with the clutch, with the weights on or off, which weights should I put on and how do I know where to put them?

This is on a 93 cobra btw.
 
Unless you are running an internally balanced motor, you will need to install one of the included weights. Early 289/302 and all 351W require a 28 oz-in imbalance on the harmonic balancer and flywheel/flexplate. Late 302 (I think after 1981) require a 50 oz-in imbalance on the balancer and flywheel/flexplate.

So, if you are running at 302, you will need to run the 50 oz-in weight, if you are running a 351W, you will need to install the 28 oz-in weight.

Most of the stroker kits require the 28 oz-in weight. Hope this helps.
 
Just went throgh al this research myself. Pretty sure if you are putting this on your 93 cobra with the stock 302 5.0 and not a stroker kit etc. you will need to attach the 50 oz weight to the flywheel as your stock balancer and internals will be balanced to that as well.
 
OK. but did you guys actually read my post? You answered only the easiest question of them all. I suppose if that's the only one you know then that's the only one you can answer. Can someone help me answer the rest of my questions.
 
The answer is on my screen(if you read between the lines). Use the 50oz weight. It will only bolt on in one place.You can't do it wrong. You dont need a machine shop 4 anything. Bolt it to the engine. Put clutch kit together on the clutch install tool.Put end of tool inside pilot bushing. Install bolts and torque to spec.
 
wow just my two cents but ya seem pretty snippy for someone lookin for help......I too am trying to figure out your second question....you don't need to take anything to the machine shop unless the flywheel is used, just like the previous posts say, bolt everything together and put it in. should work no problem.

I haven't posted a lot here but I have been on here quite a while so just a word of advice if you need help be polite as the guys and girls on here don't HAVE to help but want to help you.




:D