For those that have done a 4.6 cam swap

Borrowed it from a Percival, a friend of mine used to be one of their top techs. If you know somebody at either Percival or Bennett, they may lend you one.

huh?

you need a tool? lol pretty sure i just placed them under where the were sopose to go and used cam for leverage.... just go on the low side of the cam lobe... unless im thinkign somthing else...

WOT said:

Without using the cam tool to compress the valve spring first then place the rockers between the cam lobe and the lifters. You can and probably will warp or bend the cams or enen break the cam brackets. That would mean new heads

I have seen what happens when you don't use it. So I would rather spend 100 on a tool to do it right, then throw away 600 for messing up the cams or worse 2000 for new heads.

Click to expand...

i guess i got lucky i used this write up and it worked for me...

Once you know you have no clearance issues, it’s time to put the cam followers back in. The back of the follow sits on the valve and the front on the lifter. Find a cam lobe that is at the base of its circle (shortest point) and slide the follower under it so that the rear is over the valve, the roller is under the cam lobe and the front of it is directly in front of the lifter. Now take a large screwdriver and position the flat head of it behind the lip on top of the follower and pull backwards using the cam lobe for leverage (fig 15). It will pop the follower back into place. Don’t worry about the cam lobe surface it is very strong and will not scratch. Do this for all followers and make sure to rotate the motor as you go so you can access each one while the base circle is facing down.