the 89 5.0 HO motor is stripped bare, painted and ready for completion.
for putting the heads, intake manifold, and waterpump back on, am i going to need to use adhesive on the new gaskets? i was looking at some tips from the Fel-Pro gasket kit i ordered and it says to use an adhesive. if i do need this, where could i get some around town? auto-zone, pep-boys, checkers, etc? or do i need to order it online?
now to the mounting question. i bought <a href="http://store.summitracing.com/partdetail.asp?autofilter=1&part=PTP%2D6%2D503&N=700+4294908331+4294908282+4294925081+4294840126+115&autoview=sku">these mounts</a> and cant figure out if i need new frame mounts to apply to these. i had a straight 6 and dont think the old frame mounts will work
any help is much appreciated
for putting the heads, intake manifold, and waterpump back on, am i going to need to use adhesive on the new gaskets? i was looking at some tips from the Fel-Pro gasket kit i ordered and it says to use an adhesive. if i do need this, where could i get some around town? auto-zone, pep-boys, checkers, etc? or do i need to order it online?
now to the mounting question. i bought <a href="http://store.summitracing.com/partdetail.asp?autofilter=1&part=PTP%2D6%2D503&N=700+4294908331+4294908282+4294925081+4294840126+115&autoview=sku">these mounts</a> and cant figure out if i need new frame mounts to apply to these. i had a straight 6 and dont think the old frame mounts will work
any help is much appreciated