So I thought the same because the crack does not extend through the water pump flange on the bottom however, looking at the "clean" potion of the front cover, just behind the water pump you can see where the crack has opened up and some of the edges have flaked off.Hard to tell on the phone, but is it really a crack, or just casting flash?
New cover will be here tomorrow so I am going to pull her off now and look at the backside. more to followIt kinds does look like a crack but it does not go through the lower water pump mounting boss. Maybe a original casting defect, does it extend up over the top of the cover?
I thought about it but when I spoke to LMR they rushed me a replacement so I stripped her back down. Yes OCD would have got the better of me! Ill have it back together tomorrow!!Try the JB Weld you can always pull it and change it if the JB doesn't work. You might be able to lay a bead down so it won't even look bad.
Now if you have unlimited time and funds or are OCD just change it know so you don't drive yourself crazy thinking about it.
Good luck
I've had my last water pump leak , turned out the two bolts that are on backside. I ground down an old wrench and that worked.Try the JB Weld you can always pull it and change it if the JB doesn't work. You might be able to lay a bead down so it won't even look bad.
Now if you have unlimited time and funds or are OCD just change it know so you don't drive yourself crazy thinking about it.
Good luck
awesome you got it fixed one less thing to worry aboutI thought about it but when I spoke to LMR they rushed me a replacement so I stripped her back down. Yes OCD would have got the better of me! Ill have it back together tomorrow!!
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?