Front lower control arms off a 2000

5.0TailPipeHump

Member

Dec 5, 2006

153

0

17

May 20, 2008

#1

• May 20, 2008

• #1

Im wondering if the front lower control arms will fit on my fox' i came across some at a wreakers and if they will fit i will be going to pick em up' there off a 2000 mustang.



If they wont fit what will' ill be replacing my ball joints soon and would like to upgrade along the way.
Any suggestions would be awsome. These are at a wreakers and could be had for cheap.

 

skunk21

Active Member

May 22, 2007

1,203

3

36

Taxachusetts

May 20, 2008

#2

• May 20, 2008

• #2

No I don't think so, I'm like 90% sure. I looked through all my catologs 50resto, maximum motorsports, cjpony parts, etc and looked online for you and everyone lists lower control arm for the fox 79- 93 then new part #'s for 1994 all the way to 2004. I'm thinking they longer. I would get the ford racing lower arms with upgraded better lower ball joints, I have set and most recommend them, great bang for the buck. I could be wrong just going by the info I found unless someone has something different.

 

samickguy15

Member

Sep 1, 2005

404

0

16

Delavan, IL

May 20, 2008

#3

• May 20, 2008

• #3

94+ will fit fox, but they increase your track width...They're approximately the same length as TC lowers.

 

5.0TailPipeHump

Member

Dec 5, 2006

153

0

17

May 20, 2008

#4

• May 20, 2008

• #4

Thanks guys ' i was looking at the ford racing control arms and might have to go with them ' i do hear that they are a great upgrade from stock ' if i do go with them and later on down the road i need ball joints what kind do i get put in there with the ford racing ones.

 

skunk21

Active Member

May 22, 2007

1,203

3

36

Taxachusetts

May 20, 2008

#5

• May 20, 2008

• #5

samickguy15 said:

94+ will fit fox, but they increase your track width...They're approximately the same length as TC lowers.

Click to expand...

Yes I did read that but It was also stated that significant fender modifications are required.

5.0TailPipeHump said:

Thanks guys ' i was looking at the ford racing control arms and might have to go with them ' i do hear that they are a great upgrade from stock ' if i do go with them and later on down the road i need ball joints what kind do i get put in there with the ford racing ones.

Click to expand...

They use the 1996 low friction ball joints.

 

L

lang williams

New Member

Jun 11, 2003

567

0

0

cleveland, oh

May 20, 2008

#6

• May 20, 2008

• #6

I put them on my 84 but the 84 has a narrower track then the later fox bodies an it still pushed the outter tie rods close the the ends of the inners.

 

Mustang5L5

That is…until I whipped out my Bissell

Mod Dude

Feb 18, 2001

43,216

17,899

224

Massachusetts

May 20, 2008

#7

• May 20, 2008

• #7

They are too wide...leave em alone.


Besides...03/04 Cobra a-arms are the only Sn95 arms to even consider..but your camber might still be excessive