I tried to install my Roush swaybars yesterday and I ran into a bit of a problem.
After the fastener on the driver side broke it just started to free spin in place and it would not come out. To make matters worse it it would not go back in either to tighten so now the car makes this loud clunk over the smallest bumps on the road.
That I could see there is no way to secure the back of the endlink with another wrench so that I could finish the job.
Does anyone have an idea on what to do now?
After the fastener on the driver side broke it just started to free spin in place and it would not come out. To make matters worse it it would not go back in either to tighten so now the car makes this loud clunk over the smallest bumps on the road.
That I could see there is no way to secure the back of the endlink with another wrench so that I could finish the job.
Does anyone have an idea on what to do now?